Lead in Water Removal – Pawtucket, Rhode Island

LEAD IN DRINKING WATER – How does it get there?

Lead found in tap water usually comes from the corrosion of older fixtures or from the solder that connects pipes. It can also come from old lead service lines from the middle of your street, connecting you to town water.  Water is known as the ultimate solvent in that it picks up a little of everything it touches as it flows through the ground, pipes, etc.  Also, when water sits in leaded pipes for several hours, lead can leach into the water supply. Measures taken during the last two decades have greatly reduced exposures to lead in tap water. These measures include actions taken under the requirements of the 1986 and 1996 amendments to the Safe Drinking Water Act (http://epa.gov/sdwa).    Also,  the U.S. Environmental Protection Agency’s (EPA’s) Lead and Copper Rule (http://www.epa.lead-copper-rule)

HOW DOES pH LEVEL AFFECT LEAD IN DRINKING WATER

pH  (short to “Potential for Hydrogen”) is the measure of acidity or alkalinity in the water. The pH scale is a logarithmic scale that usually runs from 1 to 14. Each whole pH value below 7 (the pH of pure water) is ten times more acidic than the higher value.  In following, whole pH values above 7 is ten times more alkaline than the one below it. For example, pH of 3 is ten times more acidic than pH of 4 and 100 times (10 times 10) more acidic than a pH value of 5. Conversely, a pH of 8 is ten times more alkaline than a pH of 7, etc.

As you would assume, the more acidic the water is, the more corrosive it is to whatever it touches.  The change in water supply for the City of Flint, Michigan created a new supply with a lower pH   this caused a higher, amount of lead leaching into the water supply.

LOW pH IS COMMON IN NEW ENGLAND

Finding a low pH in New England water supplies is not uncommon.  However, what town water departments do is add food-grade materials to the water at the treatment plant to neutralize the acidity of the water.  if you have a private well with low pH, a pH neutralization tank is typically installed).

However, older homes may have lead service lines.  These are the pipes from the main distribution line in the middle of the street to the individual homes.  This is a potential point of lead introduction into the water.  What any town’s water treatment facility does will not guarantee lead will not be introduced into your drinking water. They do what they can to minimize this.  .

You can also get Lead in drinking water if you have lead pipes in your home. Additionally, it can enter tap water if you have lead solder or brass fixtures in your home.   (Brass = lead & copper mix). Corrosion of lead-based materials can add to lead into water.  This is particularly true if water sits for a long time in the pipes before use.   At minimum, you should run the tap water until it becomes cold, flushing out any potential lead build-up.

WATER FILTRATION METHODS

Reverse osmosis water filtration systems are very effective at removing lead in drinking water (as well as a host of other potential contaminants) as a Point of Use device, typically feeding a separate faucet at the sink. These systems can be installed in the basement with a line feeding up to a separate faucet at the kitchen sink. There are also carbon filters that are designed with small enough pore sizes to remove lead from drinking water as well. For recommendations and alternatives, speak to a water treatment professional.

H2O Care is an established, full service water filtration and testing organization, originally formed in 1989 , servicing Northern Rhode Island, Eastern MA & Southern NH & ME.   See our published articles in Water Technology Magazines at http://publications. Contact us at service@h2ocare.com or 800-539-1100.