Nashua, NH

Water Softener Service

Water softener service is normally recommended on an annual basis as well as for most other water filtration equipment which will reduce the chances of a needed water softener repair.  It is possible to have interim operational problems (identified in later section below) which can be diagnosed and remedied by the homeowner.  To ensure proper operation and to maximize the useful life of your equipment, proper water softener service will provide consistent softened or conditioned water to your home.  For higher levels of iron and/or manganese, an up-flow water softener (versus down-flow) is highly recommended to avoid damaging mineral build-up at the bottom of the tank.  For complicated problems, contacting your water treatment service technician for water softener service is your best option.  See some symptoms of potential problems with your water softener below.

Water Softener for hard water Nashua, NH

IF YOUR WATER SOFTENER ISN’T WORKING

Make sure the water softener is “on” and working, that is, that the system has power, then:

  • Check the Salt (or Brine) Tank: Is there salt in the brine tank?  If not, add several bags.
  • Check  power to the softener: If the unit uses electricity to run a timer, be sure it’s plugged in to a live outlet and has power. Some water conditioners use a low-voltage transformer to power the control – be sure that device is present, plugged in, and working.  Also, a power failure could cause the timer to be improperly set.  Re-set the day of week and time of day on the water softener timer after an electrical power failure or after the softener has been powered “off” for a time.
  • Check water softener bypass valve: You want first to see that the water softener is not on “bypass” – is household water flowing through the unit?  This valve is an option and may not be installed on your unit, but there may be standard plumbing valves or globe valves that accomplish the same purpose.
  • Manual regeneration cycle: Then try a manual regeneration cycle – you’ll see on most units a lever you can push on the control box to start that regeneration process.  Note: your home will not be delivered conditioned or softened water while the water softener is in the regeneration cycle, therefore, its best not to use water (or use as little as possible- flushing toilets is OK, etc.) in the home until the regeneration process is complete.  This is why most programmed regeneration is set for late at night when water usage is much less likely.
  • Feel and test the water supply: if you can’t get a lather when bathing the system may not be sufficiently treating the water.
Water softener service near me Nashua MA

High Efficiency Water Softener

SOME OTHER POTENTIAL WATER SOFTENER SERVICE SYMPTOMS:

water softener repair nashua NH

Without fully diagnosing, it can be very difficult to determine what is really causing the problem and whether of not water softener service is even necessary.  This is where a service technician will be able to trouble shoot the situation and come to a determination and solution to the problem. While there are so many possible symptoms and problems a softener may experience, the following are a few that you may see.

  1.  Excessive salt usage by the system is requiring higher than normal salt tank fill ups
  2.  Staining on home fixtures even though the water softener seems to be running properly
  3.  Mineral discharge from the water softener and into the home’s water supply
  4.  Loss of water pressure in the home’s distribution system downstream from the softener
  5.  Hard water evidence observed right after a regeneration cycle.

Water Softener service Nashua, NHWater softener service Nashua NH

H2O Care is an established full service, regional water filtration and testing organization, originally formed in 1989, servicing Southern NH & ME and Eastern MA.  See our published articles in Water Technology Magazines at http://h2ocare.com/pub. Contact us at [email protected] or 800-539-1100.